I n t r i n s i c D e v i c e s I n c o r p o r a t e d
I n t r i
n s i c D e v i c e s I n c o r p o r a t e d
UniLok
Braid Termination Rings
Intrinsic Devices produces a family of heat shrinkable rings as a drop-in
replacement for TE Connectivity (Raychem) Tinel-Lock®
rings. These rings are used to terminate cable shielding braids to connector
backshells. The backshells, also called adaptors, are machined with a specially
textured cylindrical surface where the ring clamps the braid. Various connector
accessory manufacturers can supply these backshells.
We offer the standard Tinel-Lock® A and B sizes from 04 to 18. The following documentation is available.
PD BR UniLok Braid Termination Rings
This is a tabulated drawing showing the dimensional specifications of the available
ring sizes.
PD013 BR Selection Guide
This shows braid sizes that can be used with each BR ring size. If you have
been using other braids with TE’s rings, you will achieve the same results
with our rings.
BR Part Number Cross Reference
Cross reference to Tinel-Lock®
part numbers.
PD014 BR Installation
This describes the steps for positioning the braid and ring on the adapter,
options for heating and how to remove rings.
SE003 BR Performance
Specification
Braid terminations made with Intrinsic Devices rings will meet the requirements
defined in the specification.
Testing of UniLok BR Series
Braid Terminations
This reports documents the test program we ran to demonstrate that our BR rings
meet the performance requirements laid out in TE’s MPS-101 rev. H Performance
Specification for Tinel-Lock®
Rings. It also offers a comparison to demonstrate that our rings meet the dimensional
requirements of TE’s Customer Drawing TR rev. E Tinel-Lock®
Ring.
PD012 Braid Termination
Barrel
Defines the dimensional requirements for the adapter rear termination barrel
where the ring will clamp the braid.
Please note, BR rings are bulk packaged, typically in plastic tubes. They are not individually bagged and tagged.
Please email for information on price and delivery.
sales@intrinsicdevices.com
 |
BC Series Braid Termination Rings We also offer braid termination rings for smaller cable assemblies. Our BC series rings are offered in 02 and 03 entry sizes. The rings can be used for single layers of 36, 38 or 40 AWG braid. The diameter of the fitting is adjusted to suit the wire gage of the braid used in the assembly. See the documentation at the links below. BC Series Ring Drawing (PDF) |
Tinel-Lock®
is a registered trademark of TE Connectivity Solutions GmbH, Mühlenstrasse
26, Schaffhausen Switzerland 8200
Copyright
2003 Intrinsic Devices, Inc. All rights reserved.